This wiring harness is for locos that use a NiMH battery or sngle Lithiium cell requiring a simple 2 wire connection. This harness should not be used for multi-cell Lithium type batteries as these must be used with multi-pole charge connection. The harness includes a battery socket, inline resettable fuse, on/off switch, charge socket and bare-end power leads for connection to your receiver.

The standard configuration comprise a selection of socket for the battery, 100mm battery / receiver power leads, toggle on/off(charge) switch, and a 50mm lead to a selection of charge sockets. The wire lengths may be changed and connector selections made using the menus below.

Battery Connector:	JST-RCY battery connector (standard) 2 pin JST-XH battery connector 2 pin Molex 2mm pin 1 negative
Resettable Fuse:	1.1A 16V : +£1.00 2A 16V : +£1.00 2.6A 16V : +£1.00
Battery Lead Length:	100mm battery lead (standard) bespoke battery lead (W1) : +£0.50
Switch:	Miniature toggle switch (standard) Miniature slide switch : -£0.80
Charge Socket:	5.5/2.1mm DC charge socket (standard) 5.5/2.5mm DC charge socket 3.2/1.5mm DC charge socket : +£2.00
Charge Socket Lead Length:	50mm charge socket lead (standard) bespoke charge socket lead (W3) : +£0.50
Receiver Lead Length:	100mm lead to receiver (standard) bespoke lead to receiver (W2) : +£0.50
LED2:	LED2 is to show receiver status when the receiver is completely enclosed within a loco body no LED 3mm LED in bezel mount : +£1.50